• You can now help support WorldwideDX when you shop on Amazon at no additional cost to you! Simply follow this Shop on Amazon link first and a portion of any purchase is sent to WorldwideDX to help with site costs.

Amp builders ?..

Oatmeal

Active Member
Mar 22, 2009
484
78
38
West Virginia..
I have seen a couple builders using those Megawatt power supplies in a amp or two they was building, why are they using them ?......just curious, I saw somewhere one of them made the remark it wasn't holding the right voltage the amp needed while under a load, the guy then added another ps.......
 
Last edited:

A regulated power supply is a step up from the unregulated supplies in some cb amps. As long as the builder uses an adequate size supply, they aren't being affected by RF or causing receiver noise I don't see anything wrong with using one. The main reason is probably cost. Lighter weight makes the amp cheaper to ship too.
 
The P/S is one of the most expensive part of any amplifier.

The more watts you want the bigger the PS needs to be amperage and high voltage.
 
  • Like
Reactions: Crusher

dxChat
Help Users
  • No one is chatting at the moment.
  • @ heartbreaker3473:
    Hello gentlemen and Ladies. I have the dreaded RCI-2990 receive issue where my radio gets distorted when people get close to my location. I found the C90 Capacitor, but I can not for the life of me find the C89 capacitor. Can or does anyone have a picture of the exact location of C89 ? Thank you in advance, Wes
  • @ AudioShockwav:
    Wes, it's better if you start a thread on the main forum, more people are going to see your question.
  • @ heartbreaker3473:
    Okay, sorry, will put in a forum
  • @ heartbreaker3473:
    I put it in the general disscution help area and started a new thread. Thank you for letting me know.