• You can now help support WorldwideDX when you shop on Amazon at no additional cost to you! Simply follow this Shop on Amazon link first and a portion of any purchase is sent to WorldwideDX to help with site costs.

Curious: What is your best solution for solder mask removal?

Dr_DX

WDX-861
Jan 29, 2006
430
542
103
I generally use a very fine sand paper (1000+ grit) or emory cloth when I can get to it. If it is hard to reach, then a jeweler's straight slot screw driver with a sharp tip. I haven't found a chemical solution that I would risk using. Looking for a better solution if it exists. Something that could be used in Dremel would be ideal.

I know there are conformal coating removers, but I haven't found them to be very effective against solder masks.

Thanks,
Dr_DX
 


dxChat
Help Users
  • No one is chatting at the moment.
  • dxBot:
    Tucker442 has left the room.
  • @ BJ radionut:
    LIVE 10:00 AM EST :cool:
  • @ Charles Edwards:
    I'm looking for factory settings 1 through 59 for a AT 5555 n2 or AT500 M2 I only wrote down half the values feel like a idiot I need help will be appreciated