• You can now help support WorldwideDX when you shop on Amazon at no additional cost to you! Simply follow this Shop on Amazon link first and a portion of any purchase is sent to WorldwideDX to help with site costs.

Done with my initial install....I'm sure it'll change;)

Regulator

Member
May 23, 2006
3
0
11
Finally finished my install on the 2003 Cheby.

The Radio is a Uniden PC68xl. Just your standard AM CB radio. I also have a Texas Star DX399 under the cupholder.

I had to trim the back of the pocket that the radio sits in. There is a bump in the back of the pocket that looks like it is used as a stop and location point for some factory available accessory, dunno. Either way, with about 10 minutes and a dremel, it was no longer an issue. The power and antenna wires wrap under the radio and go back to the area under the cup holder. It is a friction fit, with no wiggles whatsoever. Sound from the speaker has a couple of "ports" on each side of the radio to escape, so no external speaker is needed. I can also slide the radio out a bit and add some walkman head phones if desired (for those long trips with the wife and kids in the truck).
The cool thing (literally) is that I had to trim the A/C duct under the console to get the T/S to fit properly, so now there is a supply of cool air to keep it, and the radio, happy in the Texas heat.


http://i60.photobucket.com/albums/h39/chappell2006/Jun26_0003.jpg
http://i60.photobucket.com/albums/h39/chappell2006/Jun26_0004.jpg
http://i60.photobucket.com/albums/h39/chappell2006/Jun26_0005.jpg
http://i60.photobucket.com/albums/h39/chappell2006/Jun26_0009.jpg
 


dxChat
Help Users
  • No one is chatting at the moment.
  • @ heartbreaker3473:
    Hello gentlemen and Ladies. I have the dreaded RCI-2990 receive issue where my radio gets distorted when people get close to my location. I found the C90 Capacitor, but I can not for the life of me find the C89 capacitor. Can or does anyone have a picture of the exact location of C89 ? Thank you in advance, Wes
  • @ AudioShockwav:
    Wes, it's better if you start a thread on the main forum, more people are going to see your question.
  • @ heartbreaker3473:
    Okay, sorry, will put in a forum
  • @ heartbreaker3473:
    I put it in the general disscution help area and started a new thread. Thank you for letting me know.