• You can now help support WorldwideDX when you shop on Amazon at no additional cost to you! Simply follow this Shop on Amazon link first and a portion of any purchase is sent to WorldwideDX to help with site costs.

FS: Palomar 400 Elite 4x SD1446

CB590

W9WDX Member
Jun 29, 2016
1,539
1,255
173
Trenton Nj
www.590dx.com
Up for consideration is my 400 Elite HD. Been running for like 8 months or so as a base setup. Ran with Ranger 296, AT6666 (on low power) and currently Galaxy 86v (on low power). Pre-Amp does work.

Upgraded to a custom built one, so selling this one to fund the other.

Lower 48 states only. PayPal payment as goods and services. Message me for my info. Shipped with tracking.

Asking $265 shipped.


Currently has 10 awg wire on it. You may want to change or just solder the harness on board. No warranties, expressed or implied. Keep drive down to I'd say no more than 25w PEP to keep it clean and AM dk about 2-3w max. in my opinion.

Pics. Vent holes were in cover when I got it.

D21FBCF6-1AA6-49C1-A6C2-91A540FF4F86.jpeg EBC5C082-039D-448E-B5D7-4323CC8EB05A.jpeg F328BE01-648E-4292-904E-C0D3F931E3CF.jpeg 53E37773-C108-4D34-9BA7-0F51104439AB.jpeg E650FFD5-714A-4BC5-A2BF-BD67721819A6.jpeg 3F764328-6911-4636-9EB1-D31AF0B3C619.jpeg 92A5C4B8-CEDD-45D2-B6D4-B27507422552.jpeg


Here is a video link to functioning. My meter only goes to 300w. This was done in SSB mode to show the swing. I usually run on Medium to keep my meter from "popping".

 
  • Like
Reactions: Slowmover

Mouser electronics comes to mind.
They burn up from too much drive.
They simply bleed off some of the drive in the low and med setting.
The last one here I just bypassed the whole switch and went right to the input transformer.


73
Jeff
 
Jeff,
Thank you for the resistor info. order and on the way.

Can you please show me how you bypassed the whole switch and went right to the input transformer? What wattage output are you getting out of the amp?
What's the input watts, dk, swinging watts from radio?
 

dxChat
Help Users
  • No one is chatting at the moment.
  • dxBot:
    Tucker442 has left the room.
  • @ BJ radionut:
    LIVE 10:00 AM EST :cool:
  • @ Charles Edwards:
    I'm looking for factory settings 1 through 59 for a AT 5555 n2 or AT500 M2 I only wrote down half the values feel like a idiot I need help will be appreciated