ok, any ideas whether this will work or not?
I have two 9' fiberglass poles that have mounts (normally used as flag maker polls on off road trucks).
If I start from the base using winding coil wire (unsure what gage to use??) and run it straight up the side to the end of the poll. Than turn around and run it back down to the base. (now I'm up to 1/2 wave?) now repeat for the two remaining "sides" or quarters of the poll. Have I now reaches full wave? I would than finish it in the standard way, leaving a way to tune it. Does this sound like it has possibility?
Also, if one would work at full wave, would constructing two polls of this sort and putting them in phase be better or would that not work as it is already at full wave?
Thoughts, ideas??? Thanks everyone
I have two 9' fiberglass poles that have mounts (normally used as flag maker polls on off road trucks).
If I start from the base using winding coil wire (unsure what gage to use??) and run it straight up the side to the end of the poll. Than turn around and run it back down to the base. (now I'm up to 1/2 wave?) now repeat for the two remaining "sides" or quarters of the poll. Have I now reaches full wave? I would than finish it in the standard way, leaving a way to tune it. Does this sound like it has possibility?
Also, if one would work at full wave, would constructing two polls of this sort and putting them in phase be better or would that not work as it is already at full wave?
Thoughts, ideas??? Thanks everyone