Toggle sidebar Toggle sidebar
  • You can now help support WorldwideDX when you shop on Amazon at no additional cost to you! Simply follow this Shop on Amazon link first and a portion of any purchase is sent to WorldwideDX to help with site costs.

I am looking for a picture of the Cobra2000gtl wiring of the channel board wiring.

J

jtrouter

Well-Known Member
Jul 7, 2015
261
160
53
65
I snapped the LED channel board in half so I am hand making a replacement. I have a schematic of the board from the factory service manual but it only shows 4 wires going to the board but there are more than 4 wires? So I need to know how to wire it up and would love a picture or PDF from the Sam's book so I can reassemble the channel board and get my radio back to working
Thank you.
 

THANK YOU! The Corba Factory service manual did NOT have the second part! And now that you have posted this i can now finish my hand made channel replacement board work! Thank you very much!!!!
 
  • Like
Reactions: Holydvr and brandon7861

dxChat
Help Users
  • No one is chatting at the moment.
  • @ BJ radionut:
    +1
  • @ heartbreaker3473:
    Hello gentlemen and Ladies. I have the dreaded RCI-2990 receive issue where my radio gets distorted when people get close to my location. I found the C90 Capacitor, but I can not for the life of me find the C89 capacitor. Can or does anyone have a picture of the exact location of C89 ? Thank you in advance, Wes
  • @ AudioShockwav:
    Wes, it's better if you start a thread on the main forum, more people are going to see your question.
  • @ heartbreaker3473:
    Okay, sorry, will put in a forum
  • @ heartbreaker3473:
    I put it in the general disscution help area and started a new thread. Thank you for letting me know.


      Top Bottom