• You can now help support WorldwideDX when you shop on Amazon at no additional cost to you! Simply follow this Shop on Amazon link first and a portion of any purchase is sent to WorldwideDX to help with site costs.

JF3MKC, Japan - 1 watt on 20 meters

Moleculo

Ham Radio Nerd
Apr 14, 2002
9,321
2,012
383
More WSPR contacts today. Here's an interesting one I made: JF3MKC in Japan. This was made on 20 meters with 1 watt.
 

WSPR

I will try WSPR tomorrow maybe I can get to Kentucky..ha ha...30 miles from me...great into JAPAN....
Los Angeles, lucky you have an antenna at 42 feet, I was there once..wild area for us country radio operators....GreyHound Bus Station...

DOCTOR/795
 
I will try WSPR tomorrow maybe I can get to Kentucky..ha ha...30 miles from me...great into JAPAN....
Los Angeles, lucky you have an antenna at 42 feet, I was there once..wild area for us country radio operators....GreyHound Bus Station...

DOCTOR/795

You shouldn't have any problems getting into Japan. Just verify that the PC clock is accurate, compare to an atomic clock and correct if necessary, or synchronize with time.windows.com

WSPR 2.0 is a bit different, there is a TX% slider and a box marked special(don't have the idle box checked, it won't even receive then).

About an hour ago I RX'd a beacon from VK6XT, only 10,000 miles away and it was reported to be 5 watt tx on 40M. I am just using a dipole in the attic that was cut for 20M.
 

dxChat
Help Users
  • No one is chatting at the moment.
  • @ heartbreaker3473:
    Hello gentlemen and Ladies. I have the dreaded RCI-2990 receive issue where my radio gets distorted when people get close to my location. I found the C90 Capacitor, but I can not for the life of me find the C89 capacitor. Can or does anyone have a picture of the exact location of C89 ? Thank you in advance, Wes
  • @ AudioShockwav:
    Wes, it's better if you start a thread on the main forum, more people are going to see your question.
  • @ heartbreaker3473:
    Okay, sorry, will put in a forum
  • @ heartbreaker3473:
    I put it in the general disscution help area and started a new thread. Thank you for letting me know.