Toggle sidebar Toggle sidebar
  • You can now help support WorldwideDX when you shop on Amazon at no additional cost to you! Simply follow this Shop on Amazon link first and a portion of any purchase is sent to WorldwideDX to help with site costs.

Kenwood TS-140S issues

B

baco

Member
May 24, 2005
26
0
11
South Florida
www.domini-noctem.com
I have a problem with the Kenwood TS-140S :roll:

The RIT botton is not working. When you pop it, it shows 1.2 on the RIT display but it won't change even if you move the RIT pot. Any suggestions? Could it be a bad pot or a lose wire or something more complex?

The ATT is not working either but if anyone can point me to the right direction regarding the RIT I appreciate it.

laters..

Baco
 

OK looks like no one had this problem... during further investigation I noticed the RIT pot does change frequency in 1/4 or the total range of the pot at about 1500 hours position. I suspect this is just a matter of a dirty or bad potenciometer.

_
Baco
 

dxChat
Help Users
  • No one is chatting at the moment.
  • @ BJ radionut:
    +1
  • @ heartbreaker3473:
    Hello gentlemen and Ladies. I have the dreaded RCI-2990 receive issue where my radio gets distorted when people get close to my location. I found the C90 Capacitor, but I can not for the life of me find the C89 capacitor. Can or does anyone have a picture of the exact location of C89 ? Thank you in advance, Wes
  • @ AudioShockwav:
    Wes, it's better if you start a thread on the main forum, more people are going to see your question.
  • @ heartbreaker3473:
    Okay, sorry, will put in a forum
  • @ heartbreaker3473:
    I put it in the general disscution help area and started a new thread. Thank you for letting me know.


      Top Bottom