Toggle sidebar Toggle sidebar
  • You can now help support WorldwideDX when you shop on Amazon at no additional cost to you! Simply follow this Shop on Amazon link first and a portion of any purchase is sent to WorldwideDX to help with site costs.

Kenwood TS-700S

E

eggman1989

W9WDX Amateur Radio Club Member
Jun 4, 2011
96
13
18
54
I just got one of these. And was wondering if anyone has used the Mutek board in it?I have read where the mutek board worked wonders for some Icom radios. Can u still get the Mutek boards? Are they worth looking in it? And is there anything else I should know about this radio or mods for it? Thanks

kj4unx
 

I used to have a TS-700A and I installed an ARR gasFet preamp into it. It really made the receiver come alive! That is the route I would take. I do not know what the difference is between the A and S versions. It was fairly easy to install in the A.

I have an Icom 251A, which Mutek made a front end board for. I procured mine recently and it has a really hot receiver, I have not looked inside to see if it has a preamp or Mutek board inside. PO did not mention it.
 

dxChat
Help Users
  • No one is chatting at the moment.
  • @ BJ radionut:
    +1
  • @ heartbreaker3473:
    Hello gentlemen and Ladies. I have the dreaded RCI-2990 receive issue where my radio gets distorted when people get close to my location. I found the C90 Capacitor, but I can not for the life of me find the C89 capacitor. Can or does anyone have a picture of the exact location of C89 ? Thank you in advance, Wes
  • @ AudioShockwav:
    Wes, it's better if you start a thread on the main forum, more people are going to see your question.
  • @ heartbreaker3473:
    Okay, sorry, will put in a forum
  • @ heartbreaker3473:
    I put it in the general disscution help area and started a new thread. Thank you for letting me know.


      Top Bottom