• You can now help support WorldwideDX when you shop on Amazon at no additional cost to you! Simply follow this Shop on Amazon link first and a portion of any purchase is sent to WorldwideDX to help with site costs.

No Power to board? But meters light up.

Bad solder joint. I was getting 13V at C172 and at a couple of places beyond that then it just stopped. Close examination of the board and I found a bad solder point. Crazy!
 
So what was the fix ???
Now back to my original and much larger problem. Have no TX power and I just burned up L39- again. Stuck because I have no idea where to get a replacement for it as I pilfered that one from an old radio. And of course even if I did have one, clearly something is causing it to burn up which I assume is also the reason there is no TX power and I would likely just burn up another one.
 

dxChat
Help Users
  • No one is chatting at the moment.
  • @ COWBOYS:
    Denton GL 1000 ham amp comes on, but will not key up
  • @ COWBOYS:
    What can I do to make my Denton GLS 1000 amp to load ?
  • @ AudioShockwav:
    Try starting a new thread in the Amplifier section and asking the question, more people will see it to respond.
  • @ iw7ed:
    hello