Would anyone know the number of turns and the diameter of the driver and final tuning coils on the skipper 300? I bought one and it is set for another band. I tried winding some using the pot luck method and helped it but I would like to know the right size. Thanks
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an alternative browser.
You should upgrade or use an alternative browser.
-
You can now help support WorldwideDX when you shop on Amazon at no additional cost to you! Simply follow this Shop on Amazon link first and a portion of any purchase is sent to WorldwideDX to help with site costs.
Palomar Skipper 300
- Thread starter jammeejoe
- Start date
C
CDX126
Guest
Driver, 6 turns 1 1/2 inch diameter, Final, 4 turns 1inch diameter.
Tune the amp for max and check the position of the gangs, they should be at half mesh.
If the gang is fully meshed, that means you need more turns on your coil. If your gang is fully open, that means you have too many turns.
Do not try to adjust the output or driver tank coils with the amp powered on (but you knew that!).
.
Tune the amp for max and check the position of the gangs, they should be at half mesh.
If the gang is fully meshed, that means you need more turns on your coil. If your gang is fully open, that means you have too many turns.
Do not try to adjust the output or driver tank coils with the amp powered on (but you knew that!).
.
Thank you, I will try that in the morning. And yes sir I won't touch the coils powered on. Again Thanks
dxChat
- No one is chatting at the moment.
-
-
@ heartbreaker3473:Hello gentlemen and Ladies. I have the dreaded RCI-2990 receive issue where my radio gets distorted when people get close to my location. I found the C90 Capacitor, but I can not for the life of me find the C89 capacitor. Can or does anyone have a picture of the exact location of C89 ? Thank you in advance, Wes
-
@ AudioShockwav:Wes, it's better if you start a thread on the main forum, more people are going to see your question.
-
-
@ heartbreaker3473:I put it in the general disscution help area and started a new thread. Thank you for letting me know.