Palomar TX100 Repair Question

[KB1TPX]

I need to replace one of the 22uH chokes, which fried as the result of a low amperage power supply. (lesson learned).
Question is, what would the ampereage be for that choke? It is a wire wound, ferrite bar type. The schematic doesn't specify the ampereage for it.

http://www.cbtricks.com/Amp/palomar/tx75-100/palomar_tx75-100.pdf

 

[KB1TPX]

OK. let me put it another way,

I confess that I do not know how to identify this choke (inductor) other than to say that it is a 22uH, is wire wound, is about 1/4" long 1/8" in diameter. It broke in half when desoldering it.
Can anyone tell me what to ask for when ordering one online? If not, I'll have to drive quite a distance to buy one at a supplier and if I do that, I'll just take the unit with me and show them what the choke looks like.
Attached is the schematic.

 

[Monk]

Rewind choke

Check the wire size and go to Radio Shack and get as close as you can. Strip off old wire super glue the core back together then rewind with your new wire. Good enough.

Monk

 

[KB1TPX]

OK, but, the reason I removed it in the first place was because it had heated up to "glowing" (stunk too) and I needed to replace it.