This mic has been collecting dust for at least 5 years so I got bored and decided to take a shot at replacing the switch. Since it was a spur of the moment decision and it had to be done NOW, I grabbed a beat up 636 that was given to me with a radio and used it's switch as a donor.
Somewhere along the line I must've attempted to take the cover off and disconnected most of the wires in the process. I don't recall doing this, but there is no other explanation. Using the photo below from the Copper's site, I replaced the switch but cannot figure out where the white wire goes. I have everything else in place and it seems to be in working order with one minor exception: it's not transmitting.
Anyone know where the white wire goes after passing under that cap?
Thanks.
Somewhere along the line I must've attempted to take the cover off and disconnected most of the wires in the process. I don't recall doing this, but there is no other explanation. Using the photo below from the Copper's site, I replaced the switch but cannot figure out where the white wire goes. I have everything else in place and it seems to be in working order with one minor exception: it's not transmitting.
Anyone know where the white wire goes after passing under that cap?
Thanks.
