You can now help support WorldwideDX when you shop on Amazon at no additional cost to you! Simply follow this Shop on Amazon link first and a portion of any purchase is sent to WorldwideDX to help with site costs.

Reply to thread

Message

im learning how to use the equipment. today i hooked up the signal generator using the schematic, to the pin 13 the output of the mod board.i put the signal on 27.115mhz ch 13 and on the radio ch 13. and clip a rf probe to the antenna jack on ac im guessing about how to hook it up. when i key up on ssb it is the the same low signal.but when i unkey i hear the signal loudly in the speaker and then it fades away. i can repeat this on ssb and am the meter at the antenna jack reads with the signal on ssb .135vac and on am its 1.57vac. its .0vac without a signal. i am stumped

[QUOTE="klj2497, post: 677942, member: 49035"] im learning how to use the equipment. today i hooked up the signal generator using the schematic, to the pin 13 the output of the mod board.i put the signal on 27.115mhz ch 13 and on the radio ch 13. and clip a rf probe to the antenna jack on ac im guessing about how to hook it up. when i key up on ssb it is the the same low signal.but when i unkey i hear the signal loudly in the speaker and then it fades away. i can repeat this on ssb and am the meter at the antenna jack reads with the signal on ssb .135vac and on am its 1.57vac. its .0vac without a signal. i am stumped [/QUOTE]

Top Bottom