• You can now help support WorldwideDX when you shop on Amazon at no additional cost to you! Simply follow this Shop on Amazon link first and a portion of any purchase is sent to WorldwideDX to help with site costs.

TriStar 240 alignment?

Cable Guy

Growth must be chosen again and again.
I Support WorldwideDX.com!
Dec 29, 2010
1,194
1,246
173
413-West Tennessee
A local has a stash of these, sent me one to look at. He is fond of them. Cbtricks wasn't very helpful this time. I did find a schematic. It looks simple for a dual conversion, but not like anything else I have seen. Is this chassis shared with a more detailed rig, particularly alignment info?
IMG_20250507_064928195.jpg
This unit was not operational. No rx. The audio chip was getting hot (kia7217pa) due to pin 10 being shorted, I first checked for shorted caps on the output, but no, the chip itself was shorted. I found one kicking around my scrap pile and put it in, seems to work now. The audio is kinda distorted so I might have to recap the whole thing for good measure. Fortunately this rig is cap sparse, count approx 20+ with a quick glance. Given the age, I expect this.

Edit: found some tune up info on the secret cb vol 25. Not service manual alignment info but a step in the right direction.
Screenshot_20250507-073601.png

Edit: that secret cb info is for a different radio using a different pll and crystals. This unit uses the mc145106p like many older Galaxy/ss units, and as such, does not match what the pub suggests. Onward I go.
 
Last edited:


dxChat
Help Users
  • No one is chatting at the moment.
  • @ heartbreaker3473:
    Hello gentlemen and Ladies. I have the dreaded RCI-2990 receive issue where my radio gets distorted when people get close to my location. I found the C90 Capacitor, but I can not for the life of me find the C89 capacitor. Can or does anyone have a picture of the exact location of C89 ? Thank you in advance, Wes
  • @ AudioShockwav:
    Wes, it's better if you start a thread on the main forum, more people are going to see your question.
  • @ heartbreaker3473:
    Okay, sorry, will put in a forum
  • @ heartbreaker3473:
    I put it in the general disscution help area and started a new thread. Thank you for letting me know.