Toggle sidebar Toggle sidebar
  • You can now help support WorldwideDX when you shop on Amazon at no additional cost to you! Simply follow this Shop on Amazon link first and a portion of any purchase is sent to WorldwideDX to help with site costs.

Turner + 2 mic wiring

Gee Hotrod I thought you were testing me . lol I went wirh my gut an the SSK on this one ! The best part was figuring out I could make a $6 battery using five watch batteries that cost 75 cents !
 
  • Like
Reactions: 1 person
Turner +2 is rely-switching from the factory, the 140 is, I believe , electronic-switching. You need to reverse the red and black ground wire to show the three tabs ,left to right 1-black ground, 2 or middle tab-red, right tab black, shield to mount, White to upper left switch connection. These connections are inside the Mic. If radio is supertuned(volted) A resistor might be needed to cut down squeel, a 4.7K is a good start goes across audio to shield. If needed add 1K at a time
 
Last edited:

dxChat
Help Users
  • No one is chatting at the moment.
  • @ BJ radionut:
  • @ COWBOYS:
    Denton GL 1000 ham amp comes on, but will not key up
  • @ COWBOYS:
    What can I do to make my Denton GLS 1000 amp to load ?
  • @ AudioShockwav:
    Try starting a new thread in the Amplifier section and asking the question, more people will see it to respond.
  • @ iw7ed:
    hello


      Top Bottom