UNIDEN PRO 810E VARIABLE POWER MOD

[440denver]

Anyone know how to put a variable power output on a uniden pro 810e base?

 

[440denver]

Wow.Must be rocket science!

 

[theshortcircuit]

Perform an internet search for Plowboy's variable power modifications*, apply the diagrams and instructions he provides to the schematic of the Uniden Pro 810 that can be found at CB Tricks.

*Then again, I've never seen this radio and maybe it uses something like an MRF 477 high drive final complicating the process to a degree that would make rocket science look like childs play.

 

[Switch Kit]

just a PC-122 in a base form . VR-10 should be AM power . You could pop vr-10 out and use a variable switch at 1 k or so . (not sure on the radio) you may also be able to use one of the switches on the radio depending on what value it is.

And your right . It's not rocket science. You are right theshortcircuit , Plowboy is good people. If your not to sure about all of this 440 ? You can even write Plowboy if need be. IM sure he will get back to you within 24 hours or so.

Oh , and that rocket science remark , come on 440 ! it's a many dollars in many folks pockets , so why should they tell you . It's all good 440. Guys like Plowboy and many others like him are not much liked by the establishment of send it to me with all your green. Good luck dude

 

[440denver]

Well,vr -10 is the internal adjustment for the power.I should just be able to swap it out for an external pot that I can control from the outside.Just need to know what value pot?