Recent content by 66gto

Thanks for the info-Picture wish it was in color. Black and white will do. Thanks again.

Need info for a Grant XL SSB 8719 with PB-208AB board. Need the main board PCB layout.Looked all over came up with alignment info and mods. ,but nothing on the pcb Layout info????? a picture of componints and thier position on the board. Thanks

Thanks looks like what i needed. you hit the nail rite on the head =old saying. Kudoes. Thanks again.

Been going in circles trying to find INFO on( Galaxy Saturn Alignment info.) Have the EPT360014 Board Any help would really be appreciated.

Need some help hard to finf for info on Galaxy Saturn. i need alighnment info and maybe a schematic. i hope your still around to help me. thanks garyprososki@hotmail.com. any help will make my day.

Thanks RCI Guy I'll check

I pulled the rear bord about ten days ago ,found nothing wrong. still looks like new. also before i replaced all 4 pills i checked them on my peak atlas DCA55 they all were within 4 points on the hfe. also i watch a lot of u-tube to see if i can get info about this problem. hard to find. ihave...

I already did that. I don't completely remove them i unsolder the base & collector. I have a Peak Atlas DCA55 they show O.K. like i posted. i checked base resistance and voltage they are spot on. All 4. Something else is throwing the Tune Off , I think a capacitor is the culpret. I changed 7...

I replaced the combiner with the proper one.Keyed it up and the output wattage went up with a 1/2 watt input to about 100 watts. But the new combiner resistor 100 ohm 2 watt got really hot, so i shut it down after 10 seconds.Any thoughts about what could cause this new combiner to heat up so...

i checked the bios resistor on rear board. it was a 1.6 ohm which checked open thats what blew the replacement 2sc 2879 16D08. then blew the 13.7 volt plus trace. i replaced it checked the fron board same resistor it was O.K. i.m waiting for the new combiner and new capacitor C45 to get here...

Sorry about so many bad key strokes. I'M 77 years young.

sorry 50 Watts with 4 watts drive from my galaxy DX2547.

I sent it back and got the 500 that didn't work. it's about quality control. today i received more parts combiner was too big need a smaller one. also received the 1.6 ohm biasing resistor for the rear board. installed it. checked the 1.6 ohm on the front board it was spot on for it's value...

Have one 3 months old. I have had problems from the start. Never again i will purchase one...... purchased a dx 667 receive it it wouldn't work... opened it up found 2 solder joints that weren't soldered . contacted texas star told them about the problem said i couls solder the 2 places. they...