Recent content by ChrisDel157

I'll have to check, but thank you!

Yes the gain is open and it still has no modulation on all settings. Just took out the finals to check them, they're all above 85 hFE

Hi all, I have a 2950dx it receives and transmits but no modulation. I've changed mics a few times just to see if that was the problem, but nothing. A little help would be great! Thanks in advance!

ok, I've seen very little on converting this 2950 to 11 meter. 1 website said to pull jumper j2 behind the front panel. J2 is across the back next to a final! I know I have the older version, but what is the real way to convert this dam thing?? Thanks in advance!

Thank you. I might have more questions in the future. I appreciate your knowledge as well.

I have a fix! Since I work at a transfer station, I have access to electronics and other devices. So after testing, and getting 12.8v DC at the rectifier I'm going to install this temporarily until I get a replacement or maybe come across a parts radio. Thanks for sharing your knowledge with me.

Thank you Gary, you're been nothing but helpful. It's very much appreciated! I'll get this thing going again and repost about it.

One other question, on the headphone jack on the back should there be a resistor on it? It's not a film capacitor. Which I thought it should be.

The orange line goes to the other side of the fuse. I appreciate your input

Thank you for your help, I'll look into it!

Thank you for all your help bud, I still think this thing needs a new transformer... I'm only getting 9.8 ac out of the transformer. 11.3dc out of the rectifier.

Also, thank you for your help here. It is much appreciated! Hope you have a good 4thanks!

Here is the transformer (factory 110v and 220v) and here is the wiring pic from when I bought it. I don't remember the AC out to the rectifier, so I'll check it tonight and post back. I am getting 10volts out of the rectifier and 11.3 at the 35v capacitor just after it (which I think is...

Could you test the output at the rectifier? I have 10volts. I think it needs to be 13? At least I hope so

It runs 110 and 220. I know it's connected properly because the output is still the same from 220v and now 110v on the output of the transformer to the rectifier. Output of 10volts. I was hoping for 13, is that wrong?