Recent content by Ghibli69

I have already performed this modification on a first silver grant series PC-999, but this grant mounts a different circuit board the PC-999 AD with fine and coarse After the modification I always realign carrier and pll with the frequency counter.

I would like to opening a clarifier (coarse and fine), to track on receive and transmit in SSB, but I don't find the schemeatic for the PC-999AD.

This post is for unlock the clarifier, and not abou how use it. Thanks

With the modification you can use fine to tune at the same time in rx and tx. It allows the shift of + - 5 khz

I know how coarse works, but that's not the point. I want to mods the Coarse and Fine so that they work in rx and in tx.

I prefer the mods that allows me to move in rx and tx at the same time.

Because in SSB with more than two interlocutors it becomes difficult to do isofrequency.

Hi Sonoma, This is the modification I made, using a voltage stabilizer for the 8v. But the fine does not work.

the radio is like this, in the back there is also the socket for the external s-meter

Thank you for the reply, but these are the mod for the PC-999AB grant, I have tried this: 1) Cut D-45. 2) Find D-79 and jump it (Solder a wire across it) 3) Remove r-120 and replace it with a 470 ohm resistor. 4) Find the BLUE wire from the clarifier knob and cut it just before it connects to...

Hi Mike, thanks for the reply, but it is not so, with the coarse I can change the frequency in TX and RX, but with the efine it moves only the frequency in reception.

Hi I have this presdident grant ( pc-999AD ) with the black mask with the coarse and the fine. I look for the modification to unlock rx/tx the clarifier (fine and coarse) Thank's

To be clearer, the radio is called Delta Force Dragon but is very similar to the Magnum Delta Force. Looking the soldering point are homogeneous I do not think the mosfet has been change.

Someone can tell me if this radio comes out of the factory with 3 Mosfet ? Thanks

The radio mounts 3 mosfet erf2030, could it be that when the radio starts to heat up one of them, go in auto oscilation ? from schema I see that they are two mosfet and the driver is a 2SC2166, there is a version like mine with 3 mosfet ?