Recent content by mitch169

this is a really old post Did you ever find a dds-vfo for your sonar FS-23?

Variable, let's try this with the proper spelling. Could not figure out how to edit

I went with Hammer Jockey. Excellent Built 2 MRF454 with SSB Bias and Veraiable. I get 160 out

Yes, the main radio is a Flex 50000a putting out 65 watts. Then I would need a driver once I finish the restoration of the Browning Golden Eagle Mark III, which puts out about 10 watts. Then I would need one. I don't want to drive the box hard. The previous owner didn't, I asked this question...

I'm Looking to buy a driver at least 100 Watt out PEP, for a 6 Pill. It must have an SSB delay. Mitch

I already tried that. I just tried it again checked the box saved the profile shut the software off, and turned it back on. I modulated into the mic. still goes negative on peaks.

Sorry, I Thought I replied. Yes Phase Invert is unchecked in the setting of the Flex 5000a software. O I did reply, it's above. I did check, it and had the same problem. I even called MFJ The same the wires for the meter are wired backward. HAHAHAHA. Got the email They asked what band is it...

After my reply I had a chance to get on the radio and ask around. 2 other people have the same problem.

Not sure what you mean. I have a Flex 5000a with a Studio Phantom Powered mic attached to the front of the radio and made sure Phase Invert was unchecked. (pic attached)

Thank You I have given up on it. and Its amazing that MFJ would say the wires are backwards did you check it? and if they are not then the diode's backward LOL

I sent the picture to MFJ he said the wiring is correct.

I called MFJ. He said the wiring must be backwards. I said it's not I checked. He goes how did you check. I said I made sure the transmitter coax was going to the transmitter input and the antennas were going to the 2 antennas. He said No inside the radio. He goes if the wires are correct then...

Mic Phase Inverted is unchecked

Peak hold is ON

I have an MFJ-998 Intellituner and any power shows downward power as I modulate. But on my CN-801 Daiwa on AVG it shows upwards. The Daiwa is after the antenna tuner and before the antenna. I have changed different lengths of the Coax—good 213.