Recent content by Overtimeman

Well I have a RM Italy KL703. Haven't hooked it up yet.You can get different opinions from the guys on YouTube.Don't want to mess anything up.On the George FCC you just key the mic and push in the selector knob and you can turn down the RF power.Bounty Hunter

OK I found my answer on You Tube.I wished I grabbed a McKinley 2 just for the smaller size.Too bad they were a limited production run.

Finally got me a George FCC radio.My present setup is a mobile with a Bill II,with a digi mic,KL300P,and the Stryker A10 antenna.Got the Bill 2 running a watt and a half into the KL300 and everything is fine.My question is about the George.I don't think there is a CB shop anywhere around my...

What do you fellow CB'ers think would be a good entry level SWR/watt meter? MJF 870 or the SX100? Both have about the same amount of negative reviews.Just wondering if any had experience with these.Thanks,Bounty Hunter

On the Bill 2 you turn the radio off and hold down the AM/FM button and turn it back on and you are in the menu.Toggle with the mic up and down till you get to what you want to access and hit the AM/FM again and adjust from from there.I just wait ten seconds or press the PTT and it goes back...

I noticed a website that offers a peaked and tuned Bill 2.I know it's menu driven radio cause on mine I go from one watt driving my amp back to the four watts when I talk in my neighborhood to keep from coming through everyone's TV.I just wondered if someone discovered a way to tune a Bill 2 for...

Thanks everyone for all the help and info! Mine has the black heat sinks. 73's

Another dumb question.Can you run the high and low switch in the middle on the AM band too?I really appreciate all the help from this forum.73's

Thanks!How many watts dead key is going into your amps if you don't mind me asking?73's

I've had a Pres.Bill 2 and Stryker A 10 with the KL200 at one watt dead key.Everyone I've talked to said it sounds clear.Like every one else I wanted a little more power so I bought the KL 300P.There are no more CB shops around anymore to get advice.I don't want to overdrive the latest amp so...

Hey everyone.Been using the KL200 on my Bill2 at one watt and everyone said I sound loud and clean.What would be the best dead watt key to run the KL300 without overloading it.I wouldn't hesitate to install a fan on it but I want both amps to live a long life.The Bill2 and the President NC mic...

I getting ready to install a President Bill 2 paired with with the KL 200.Also going with the Stryker SR-A10 antenna.Would it be better to go with two watts dead key to keep the KL200 from overheating and shortening it's life.Did see one YouTube video where one user turned his PL down to 75 and...