Recent content by Skip seeker

They are expensive then you have to figure out a mount most commonly used Are the tri quad magmount with a ball joint mount and LMR coax.

Is that what most mobile operators go for that exact length of shaft for a regular car

That’s quite the setup there I’m wondering if that Rocketbox HD 500 would be a good Amp to match with a stryker 955

I still prefer the old style look Of the Stryker with the chrome Bezel compared to the dull looking anytone , but I do like the compact design of the 6666 a lot of radio operators Enjoy using them and the compact design would be a good choice for a mobile radio.

Looks identical to the Anytone AT 6666

Appreciate the lift on radioddity I haven’t looked into that Brand are they similar to the CRT brand of radios. Holy smokies that’s a very simple requirement I’m taking it once you cut the white wire you should separate the ends so they can’t touch.

I no Appreciate Everyone replying.

I could just buy a stock radio there is a Filipino Ham operator based in Houston that’s knowledgeable and would have the proper test Equipment needed for an Allignment Paying 4 and 1/2 Bills for a radio you just wouldn’t want any of these truckstop techs messing inside

I just thought it strange that the work bench looked preety Bare with regards to test equipment, I wasn’t aware they left the factory more than less plug and play you see a lot of radio shops charge $45 upwards to convert to 11 meters

I’m basically Looking information on modifying an export radio to be able to broadcast on 11 meters , I’m considering buying a stryker SR 955 + from a shop a mobile trailer radio shop in Houston Texas after a check on There website and saw photos of there work bench I couldn’t see an Analyzer or...

Can there be anything done with the display on The older models I have a 2004 Model hard to read if not directly in front of the radio could the display be changed or updated

I have a 2004 Model with the darker readout that’s hard to read at an Angle but on The plus side it has the Bi polar finals , from what I’ve Been told ranger changed to mosfets in 2006.

I’m going that route

has anyone here that’s owned a ranger RCI 2950 DX ever installed an RFX 75 to the rear of the radio what were the Benefits extra power , and also time to carry out install the issue with this radio is it lacks output power