Search results

Thats fine. When u key it it will drop down

They used to float at 18-20 and drop to 14-16

Paging @Crusher

Mgs4u should be able to sort u out

So just an update. Earlier this year after this thread was posted. I put an old stock wilson roof mount on my truck with a sirio fighter p-5000-pl. It had the fold over lever thing. Seemed well made. Tuned very easily. I check my SWR every day as a normal matter of course. Its the first thing i...

What is the swr on 1, 20, and 40?

Id just buy a set of Penta

What is the swr on 1, 20, and 40? It sounds like you just need to retune your antenna

Any single coiled cb antenna mounted on the vehicle roof in the middle will usually tune to around 1.2-1.3 : 1 swr. Antennas without a coil will usually tune to slightly below that to maybe 1.2- 1.1 something. Impedance when measured on an mfj or something will usually be 37-40 ish ohms. If...

Couldn't have said it better myself. I know why ameritron still built with them. From a commercial perspective its a familiar part, its still produced, and somewhat affordable. It also has a pile of other issues like huge long wires inside of it that you need to engineer yourself around. A week...

Do a ground connection at each end of the coax. Use whatever you have on hand.

ive seen 1kw out but it is VERY hard on the tubes. It also weighs more than my mother in law. Its a huge case. I hated mine. reliable box though.

CB goes to the motor Maul input. Never put anything more than the radio into the motor Maul

To be honest that's probably the neatest looking sweep toob box I've ever seen.. to my untrained eye it just looks fairly neat.

7.5ft of 75 ohm 84% coax as matching section.

Whoops. So 12.33ft+ 12.33ft + 6.165ft + 6.165ft

Ok so 12.5ft on the tall sides, 6ft on the top and bottom.

I found a formula that says 1005/freq. So that comes out to 36.94 feet. I guess 2:1 for the rectangle shape would be ok? Feed it from the side for vertical polarization. How do i calculate the 75ohm coax feeder? Just use the vp of the coax and calculate a 1/4 wave?

Ive been wanting to play with this for years now. I think im ready. Lol. I think id feed it from the side to get vertical polarization right? That article doesnt give formulas for length or proportion etc. should i just use the available formulas for antennas of wire for a ful wave? Could i use...

I worked on a swinging choke supply. It was 1.2a and the choke was a peter dahl marked 2-4hy. The choke was literally 70%the size of the plate transformer.