Search results

Looking at mosfets component side the gate is on the far left?? and does the ground have to be on the pcb or will the chassis work?

Hello little late for a post (6 months) but here goes: I received my 2970N2 couple of days ago and on low power it dead keyed 100 watts , 200 watts high power, I adjusted the high and low power and got it down to 10 watts low 100 watts high dead key,(AM) as I turn up the mic gain will rise to...

The difference between CBers and Ham Radio operators is like the difference between the Jocks and the Stoners in High School, we all hung out with both. depending on what was going on.

After I posted here I found Klondike Mike, He replied almost immediately!! So I ordered the caps and they are on the way. Looking forward to the project

Sonoma Were can I buy the cap kits?? looked on ebay but the boards do not match, my board is a PC-353BB Thanks

858 Chassis, voltage stable 14.8v, looks like the cap was already replaced, according to the service manual ALC and AMC do not affect SSB Re aligned SSB and got up to 80% Modulation at 10 watts by lowering output I got higher modulation. Looks like someone has made a few mods on this radio...

I installed a on/off switch to bypass the original switch, so looking at the cap is the next step I will reply with results Thanks Plumber-G

In SSB when I raise the mike gain the modulation and power goes down, on AM solid 4 watts 100 modulation. radio does not swing, what am I nor doing or need to do?? Thanks Plumber-G

Fired up the radio today everything just fine...... after about 20 minutes the display shows "PA" and none of the buttons or the frequency dial work except for the dimmer button. When I transmit the display returns but then goes back to PA. Any ideas what could be the problem?? Thanks George