Search results

http://www.dnjradiowaves.com/catalog/index.php I placed an order on 1/2/07 and never got it. Paypal and my bank are working on it, this guy don't answer E-mails or phone calls, my patience ran out. Don't get taken by this guy! His EBAY ID Is DJHED2003

What happened to the slug in L20?

You should have used a 47uf cap. And you did not put shrink tube or even tape around the Tip31. it is going to short out against the heat sink. And I don't see the ground wire coming off the pot, maybe I missed it.

Had the cable for a year, and then my whole complex caught on and it went to S#@%. The management will not let Comcast upgrade the wires for some stupid reason. So i've been using Verizon DSL for over a year, it's not as good as cable but much better than dial-up.

This guy is OK. LP Electronics 1031 Waverly Ave Holtsville NY 11742

I've done those mods quite a bit lately (CBRETARDS) and got good reports on all radios done. If you're not putting the variable in, just follow the instructions and try different value resistors until you get a DK 1/4 of max swing. Example: DK 5w Swing 20 For the 29's I usually get that...

Do you really have to ask? You know who tunes them.

VR4 is for power (WATTS). if D11 is cut, then it's just sitting there doing nothing anyway.

Thank you pluto!

Which resistor did you end up with? I have to put a bulb in a 29ltd.

I just got a reply from an e-mail I sent him a while back asking how he was. Wreckless@bulloch.net passed away November 8, 2005, This is his wife and I'm just getting around to checking his emails. He certainly enjoyed his time on the internet chating with you, thanks for asking about him...

Solder a 68ohm resistor across PA and ext. speaker jack on the board side of the 29. The galaxy...?

Try running wires direct to battery with 20amp noise filters. you can get the filter at pep boys for $12 Dash contacts pick up all kinds of engine noise.

You said it all! Go fight for your country but dont dare have a beer and smoke while doing it! Its BULL!

Did you overtighten it, not wanting it to fall off again and damage the insulator?

pep boys sells a 20amp inline noise filter for $12 if you use the cig lighter plug and have alt noise. works well, can be found in the car audio accesory section.