Search results

BTW: that is just not any piece of Duct Tape, that's a specialized tool and that's it storage place! .

Resurrected from the dead! .

:) .

Updates? .

It's a vacuum tube, treat it like one Class C (telegraph mode) Ua= 1000 V (max. 46,1 MHz) Ua= 800 V Imax. 66,6 MHz) Ua= 700 V (max. 85,7 MHz) Ua= 600 V (max. 120 MHz) Ia = 120 mA Ug2 = 300 V Ig2 = 10 mA Ug1=- 80 V Ig1=0 mA Pout=85 W max cathode current: 230 mA heater: 12,6 V/0,7A...

test. .

I never have seen one of those choke ever have to come into use but, you put it in just in case. My plate blocking is 2 X 465pf @40 Kv in parallel which represents about 3 ohms at frequency. .

Got any pictures of yours? :-) . .

The amp was built by Anderson in the early 1980's, it has (probably) 8908 tubes; does yours have an external transformer? .

GS-35b .

DC Blocking Capacitor Anywhere from 500 pf at 5,000 volts to 1000 pf (.001 uf or 1.0 nano-farads @5 Kv) will work. .

Did anybody here go? I heard that Charger was sending out invitation to all comers in DC Sky's-The-Limit class. .

Can you take the polish sausage with you? .

Generally speaking, those vintage models had Vibrator/Switching power suppllies powered by 2n4048 PNP Transistors. The primary of the X-former was 14 volts at 400 cps while, the secondary was usually about 400-500 vac which was fed into a voltage-doubler confiiguation yeilding 900+ volts under...

What exactly are you looking for this thing to do? Are you trying to replace the switching transformer that supplies high voltage when in mobile operation or, are you converting this for Fixed/AC operation?

Tricky CB Schematics. The schematic on that tricky site cannot be trusted, it shows a great oscillator but not the true amplifier as it is ran; important details have been omitted. When amplifiers are run with some amount of + volts on the bases it is common to use the relay to switch the...

Yes, it is a multi-band "Amateur" amplifier but, it does not have tuned input for each band, to run that thing, you need a tuner between the radio and the amp. .

Spread the coil that is coupling the driver tube to the final, you will know it is correct when you can see a peak when you tune the 50 pf cap. Follow the same procedure for the final output coil, when the plate tune gang peaks at halh mesh, you have it right. .

Turn the amp off and take a long, insulated screwdriver and make sure that the high voltage is bled off. Pull the driver tube. Re-direct the wire from Pin 3 of the driver tube to Pin 3 of the final tubes. Lift L3 where it connects to the final tubes (Pin 3) and tape it off, this removes...

Check the value of the screen resistors.