Search results

I’ve been wondering how it’d do at say fifty ft vs the astroplane at fifty

Been looking at the 5/8 Gainmaster. All sorts of noise bout it everywhere. But what’s the software say about it at different heights?

I’ve run one for years. I love it. Quick and has a pretty good spread. I prefer it over my mfj auto

Am on this radio has a very tight modulation range. Is there a mod setting or adjustment to lower the carrier and increase the modulation?

I have several radios ranging from old and simple to more current and in between. I’ve noticed that rf gain just doesn’t seem to be rf gain across the board. It seems to me that there are two different methods that have been used. One is actually a rf gain control where the sensitivity is indeed...

Maybe just a bit. Hahahaha. Amazingly it wasn’t running bad really. It’s better now but looking at those I’d guessed it’d been worse.

It was a little quiet yesterday afternoon on the ride home

See the qt80 and external noise blanker on YouTube in a mobile

Lo and behold one wasn’t a resistor plug. It was the hardest one to get to so my guess is it’s been there a min. Dist cap was arced and corroded. New wires, cap, bug and ngk resistor plugs. Most, not all, ignition noise is now gone. It’s low enough the nb can handle it. Lowered it 5 s units...

No it’s close enough. I just find it’s off a bit. I’m not talking like and additional 2 or 3 or anything. But one lags behind the other. I usually listen to static. Then fine tune it with the meter

Right. Like you said the old terms. My old arrl handbooks from way back talk about that but the new stuff don’t. We’ve lost too much by not keeping the older books. But i think by reason that it would. I wonder though if any improvement is due to just efficiency or if it’s radiation pattern...

I know we had a conversation about if resonance was your best preforming adjustment of an antenna. And swr has been beat to death too. But let me see if I can twist it some more. It’s too chilly for me to be interested in trying this right now but I’ve been curious about trying this out to see...

Like a dog chasing his tail. Fun but kind of pointless.

How’s the cap hat on your screwdriver work half way up the stinger?

If a quarter wave verticals on a vehicle is the top half of a half wave dipole, then the stretch for current maximum lies in extending the length of the antennas top half. Correct? To do this you’d need to lengthen the antenna by a cap hat, a longer vertical, or a top load coil, correct? or am...

So how to pull the current? Cap hat?

Don’t be yelling at me Mike. I’m delicate. Honestly I forget about fs meters. Thanks for reminding me.

Picked up another ap original. I’ll have to rear it apart and clean it all up. Seems to be in good shape other than the nuts and bolts of course.

I have run both 102 and loaded whips. Base load center load and top load. I’ve read all the trash on each one about compromise and on and on. 1/4 wave being my choice of whip I have to wonder, height being such a factor in any plot you see i am always looking for better or different. What’s...

I tried one. It does good for certain consistent noise from a single source. It’s not a noise blanker though. But has its uses