Search results

I can't and will not even guarantee the radios I pulled out. :) By the looks of the board is what I was going by.

Oh oh!!! The Realistic TRC-450 and I think the base model was the TRC-459? ***I wonder if there are revision changes between them that would consider them not the same.

140 GTL mobile, Monkey Ward 719 (I think its 719), President Grant (Not the one with the power plugin that is vertical, but the one that is horizontal) President Washington base radio (The one with the 3 buttons on the bottom-right). Same goes with the Uniden label radios that look like the...

Oddest conditions for me in a long time. I at least did talk to 749 out of California on 36 LSB a bit after 5 PM.

I usually was just careful putting the ribbon back in by using my finger/thumb of each hand onto either side of the ribbon cable carefully pinching (Dont have long fingernails.), then push little by little downard on each side. Surely it should go back in? :)

Good timing. Mother Nature is strange but strange enough was finally able to talk to ya! Good stuff. Thanks for the contact.

Conditions are very strange today... Stations are either strong one moment, or everyone is non existent on 37 LSB. Will keep an ear out on 40 USB.

I dont think its your case, but I had a PC68XL that was 5 KHz higher than the read channel. Turned out to be the crystal replacements I bought were the culprit. Grabbed one from a spare parts radio and it worked fine once again. I did fix a 142 GTL a couple years back where LSB worked, and USB...

Its rough here today. There was a handful of AM stations hammering. Will keep monitoring for the next couple hours.

I did went ahead and bought some 33 ohm resistors and 100 ohm resistors to replace them. Also some screws/lock washers. Probably all be here in a week. I think what ultimately happened to the amp is that someone used it with a very small power supply. The 20 amp fuse has a burnt color/bend on it...

Had a good contact with 428 just now. Conditions were good today as they were yesterday on this side. Heres to hoping 2026 is another good year for our radios.

The site loads, but I think whoever runs it has it off. I can't even sign up for it as it says "Sorry, you don't have permission for that!" Hope it isnt a permanent thing and maybe some issues need sorting out.

I didn't know he has been doing it for that long! Seasoned veteran in radios. :) Much respect to him. I wasnt even brought into this world until 11 years later lol.

Mr. NomadRadio has spoken... :)

I dont have the watt meter hooked up, but when I did, it was doing well over 200+ PEP when you set it on high. Medium its doing 140ish? This is just throwing 10 watts SSB at it. Even on Medium, its drawing around 18 amps. High its for sure draining 20 amps.

Mother Nature has a weird say to keep me in check out here in Kansas lol. But there was a short window early this year were I got into Australia at least. Though, I should probably look around .555 for better DX.

Was this the case with the old Kraco 23 channel radios? Reason I ask is because there was two versions of the 23 channel Kraco radios that looked exactly the same, but Version A had the crystals inside it.... Version B had the PLL chip in it.. Always wondered if it was as simple to swap/wire...

Pretty neat you also just have it set to Medium. My 2 pill Magnum 2000 I just keep it at medium. with yours having the four MRF455, its for sure doing better. :) ****Ooops, I mean my Palomar Skipper. The Magnum 2000 has the same 2 pills/transistors inside. Magnum 2000 I will slowly work on over...

The ALC will set your SSB watts overall. I just put my wife's 980SSB to 10 watts on SSB, then put the AMC so it was doing the 8 watts on AM. AM Power of course I set it to just under 2 watts while no modulation is happening. :)