Search results

The first page of the service manual will show some examples of the 23 Ch radios or clones that I found that use this board so far. Most of them include a FCC ID tag stating 1125. They used sheet metal screws on the case halves and even three hidden ones behind the face plates that attach the...

This is an enhanced service manual with a separate redrawn schematic of the Midland 13-857.

I don’t use any specialized program for joining those pages together. I mainly use early versions of Paint Shop Pro and ACDsee. Some of the early paint programs that I have become efficient with for the past twenty or more years. Horizontal and vertical line alignment is the key. Each page is...

I just finished the enhanced Hy Gain VIII manual with a separate spliced together schematic. The file size was a little large for this forum, so I split the manual in two parts.

This is the enhanced manual and spliced schematic that I did much earlier when it was first posted.

At this time this is the best factory manual I could find on the Kraco KCB-2340. The resolution on the schematic I saw on the CB tricks version is not high enough. It's also listed in Sam's CB 162. A volume that I don't own.

The available schematics for all the other Citi-Fhone models show the same AC power plug pin configuration, so you should be OK in that regard….I just hope you don’t run across any “Silver Mica Disease” inside those old IF cans. Knowing the value of those internal caps and replacing them is a...

Thanks for the corrected scan. This is my enhanced addition of the Citi-Fone SS with a separate spliced jpg schematic.

It looks like that GPS antenna was mounted just below the CB antenna’s coil windings. That probably didn't impact the SWR much. Especially if the GPS mount is made of plastic like I think it is.

So far this is my spliced version of the Sears 934.38260700 plus an enhanced PDF manual. For clarity I redrawn most of the long horizontal and vertical lines, but I may make additional improvements on it in the future. Short story: Back in the day a fellow ham friend fried the PLL chip on...

It reminds me of an old Lafayette HE-45 6 meter radio. This is the schematic I found. I have a feeling the general layout is similar. Tube compliment etc….

Are you still working on the HB-600? This is my enhanced version with a separate spliced together schematic.

I recently acquired an Instruction manual with schematic for the Granada CB-4. The Granada CB-4 and the SparkOmatic CB-1023 are basically the same radio. They were very common, and neither was covered by CB Sam’s or CBtricks. The radio examples I restored had bad finals and a few associated...

Homophones..Gotta love the English…:giggle:

I buy my stakes from a butcher in Buffalo. Molasses supplemented Aberdeen Angus. It doesn’t get any better than that IMO. They’re fried on charcoal, never on propane.

Yes, many other 23 channel number plates will work. I have also modified them to fit on the appropriate knob, so at least that portion is correct for the radio. The problem is that I ran out of all my 23 channel plates, so I thought I would try to obtain an exact original first. I’ll probably...

I’m looking to purchase a 23 channel knob for a recently restored Pearce Simpson Tiger 23C. Other Pearce Simpson 23 channel knobs like the Tiger Mark2 will also work.

I restored one of those myself recently.

I have many Cybernet radios and countless Cobra mics. That’s one reason I usually rewire the Cybernet radio’s jack over to the Cobra standard. That way I can always try a many different mics. Like NZ8N stated, Cybernet mics are wired upside down. Look at my bottom diagram for the conversion and...