Search results

on the 2 SSK parts I have, none have that type of switch with the plastic part.

I looked at those and it seems the positive goes to ground, but not sure if the board actually has the positive position marked correctly. If the board is marked correctly, then it's installed correctly after my re-cap, if not, and that we're not sure of, then I installed it incorrectly. I need...

You're correct, I'm getting sloppy in my old age.

I found this Taiwan 25 like the one we're working on here. Kinda fuzzy as not a very good pic, but it seems to show that I have the new one in wrong..but fuzzy pic and fuzzy eye sight.

C91 as far as I can tell, will have to research it more when I get the radio back. Won't be the first time the board was marked different than the position.

No, I saw it too as I compared the old vs new cap position you pointed to.

And thanks.

I see what you mean on this one, if you look close to the black wire on the bottom end of that cap, from this angle, it shows positive...unless the original cap was inserted wrong...which could be. On D9, I did fix that as it was clipped as you said. I guess I was just used to seeing a...

Could you tell me what component is the limiter in this radio? I think I still have some overmod as the scope shows a lot of what appears to be spiking. Thanks

A little more digging and found this one. About as good as it gets. Has a few very minor scuffs. In the box with all the original paperwork, wired 4 pin cobra. Like to get like $200

There doesn't seem to be many around. I have this one I just contacted 1118 in Louisiana on just this moment and got good reports. I have it hooked to a Stalker IX 80 channel, stock. It has some blemishes, but not as bad as it looks in the pics. Mostly just some chips around the edges. Just...

https://www.ebay.com/sch/i.html?_nkw=midland+76-300&_sop=12

I use these plastic boxes. Of course mine are a little over filled, but someone more organized would do better. But it keeps my different components basically on the same place, and I can see what's in them, and they're easy to handle and stack. I have a couple of different brands but they all...

Love the slide

OK, got the switch cleared of all the extra junk, wired to the electronic figure 3. Keys up and receives, however, no audio, or at least none without a whistle and then it's very weak. New batteries tomorrow to see if that's the issue...my luck probably not. Please, no comments on the sloppy...

Working on a M+2 Turner and it has some things I see in it that I don't know if they belong. There's a resistor (33K) from shield basically to the normally closed side of the switch, that is also connected to the capacitor to basically shield again through attachment to switch case as is the...

John Paul Jones was under rated, and in my opinion the most talented of the band. The whole enchilada

We ended up with a factory (repop) antenna for the 59 Apache, the Numark160 tuner or coupler so far. Add the Cobra 25LTD Classic and I think we're done. Covers painted to match the truck as best I could...truck is faded and I'm no paint expert...but I can shack a can.:sneaky: I need to make a...

Thanks again, about 15 watts now with the repaired diode, good n clean audio

Good eye. I didn't see it till you brought it to my attention. Will get it back together and re test. Thanks much. Always great help on this forum, that's one of the reasons I'm here every day.