Search results

thank you

HP 75 amp didn't work so well in my 2995. Ran way to hot and was heating up the whole radio. So installed a new LRS-600-12V power supply runs much much cooler. So far the 2995 is working fantastic. Set at 13.8V

thank you sir

Ok I'll check thank you Nomadradio

there is no visible electrolytic cap on the cpu board

my 2995 DX is having the memory loss issue after changing out the PSU to a HP 75 PSU. Does the fix also apply to the RCI 2995 DX?

Ok here we go. Just upgraded to a Mean Well 50 amp power supply. Works fantastic. Now when I turn the radio off and then back on memory is lost and display shows 24000 Mhz. So what gives? Is there a battery that saves the memory from the last time the radio was turned on? If there is no battery...

great thanks going with a HP hstns-p11 PSU in my 2995 DX.

Have a 2006 model RCI 2995 DX Power Supply is bad and going to put in a HP 75 amp PSU. What is the max voltage these radios can handle? Mine has the Toshiba 2290's in it. I just need a idea on what to set the power supply voltage to. Thanks for any suggestions.

thanks Jeff, that worked

that link didn't work, you have another link I can try?

ok did a little work on the 2995 DX. In the photo you can clearly see the black wire going to the positive terminal on the speaker. Don't know why the wires are reversed. Put a 100uf 16v cap across the terminals and it did help some. It's just temporary right now. Might try and go with a 150uf...

yeah I'll check back in with a small report

ok buddy, thanks so much for your time. going to tackle this in a little while, also going to put in a on/off switch for the rear amp and also tune that L8 for a little better recieve. 73

ok 100 uf electrolytic I have a bunch of those but what voltage rating is the best for that cap across the speaker?

ok great idea, something else to try. Thank you.

yeah sounds legit, I'm going to take a stab at this weekend, with adjusting L8. The white noise on SSB on my 2995 DX is terrible sounding. Wish I could get it to sound more like my Cobra 2000.

thanks buddy, I'll take a shot at this and hopefully make the receiver a little better.

Shadetree, hey just wanted to make sure that this L8 adjustment applies to my RCI 2995 DX 2008 model PCB 695015A Thanks

thanks Shadetree, I will open up the cover again this weekend and try to adjust L8. Thanks.