You can now help support WorldwideDX when you shop on Amazon at no additional cost to you! Simply follow this Shop on Amazon link first and a portion of any purchase is sent to WorldwideDX to help with site costs.
Check the main board for 12 volts, if you find it try to follow it and look for cracked traces. Some of these would crack very easly even when new.
If the main board is dead its back to the power supply and pass tranistor.
Bub73
Thanks for the reply;
The voltage regulators seem ok and every thing runs cool . I don't know what voltages I should be seeing on the IC's etc. Not much info for the 3010 on the net.
Thank's
Bub73
Anyone with a voltage chart for a Emperor 3010. I have one with no transmit in any mode. receive seems ok but no S meter bar graph and the PA works fine also..........
Bub73
The center pin of the clarifirer is the one hooked to the wiper of the pot. It should be easy to find by using your volt meter while turning the clarifirer the voltage should vary; one pin should be high B+ voltage and the other near ground.
Bub73
The Black wire goes to the little ground strip that joins the two trimmer caps on the expo, the other end goes to the radios foil ground.
Hope this helps
Bub73
Check the power cord and connectors first. I had a power cord that was damaged during storage........
Sometimes we try to hard and overlook the simple things.
73's
Bub73
Anyone know the mike plug part number for a Yaesu 2800M.
I'd like to try a different mike and get away from the rf pickup problem of the stock mike.
73's
Bub73
</p>
RCI 2970 with a loud rushing noise when dead keyed and the mic gain off, like you would expect with a power mike turned full up .
Also VR12 and VR16 ALC hilow seen to have no effect on the noise or power.
The power seems OK and audio is good in all modes, the mod limiter is intact and VR13...
RCI 2970 with a loud rushing noise when dead keyed and the mic gain off, like you would expect with a power mike turned full up .
Also VR12 and VR16 ALC hilow seen to have no effect on the noise or power.
The power seems OK and audio is good in all modes, the mod limiter is intact and VR13...
Rubber Ducky antennas ; anyone check the swr on one these on the MURS freq's.
I found 3 different antennas with over 3 to 1 swr. I believe they are tuned for 144 - 148 meg .
This would realy handicap a HT on MURS I think.
Anyone got any Ideas on how to tune one?
Bub73
</p>Edited by: <A...
This forum does not allow a single user to have more than one username. If anyone wants to change their username contact an admin and it will be done. Multiple accounts belonging to the same member will be deleted without warning.