Search results

I've read the manual several times and find it almost useless, something got lost in the english translation i suppose. I have programmed the Repeater and offset freqs and have selected the proper PL tones to work all of the local repeaters in my area. I cannot get the radio to transmit pl tone...

What are the most common problems with this amplifier beside faulty tubes?

I finished (3) Gamma and (3) Beta Rods today, not as difficult as one would think! The hardest part was getting started. Hy-Gain seems to be dragging their feet in that I ordered the parts over Three (3) weeks ago, a call to Joyce in the office twice seems to have done no good so now we shall see.

Could I have the specs or part number for the L.E.Ds? I have the same radio and my lamps are out.:headbang

That is exactly the type of thing I'm looking for. I would like to build several different "Vintage" Noise toys. I'm on a little retro kick here but don't have any idea where to pull the schematics from. I can't remember all of the toys besides the Raygun,tweety and roger beep. What ever...

Anyone have a schematic on this one?

I've had THE CRAZY JUPITER show here in Chicago on Channels19,18 and 14, for the last 5 years. This device works good to pin someones ears back. A word of caution exist. Have the radio turned down to about one watt (OR NOT). When I built the Prototype jammer I could hear it 29 miles away on a...

That is exactly what I needed! Thank You!

1.Junk radio that works. 1.solid state flasher relay. 1.old big tool box. 1.Big fat rubber band. 1.used car battery that will still hold a charge. 1.Junk mag mount antenna. Camo spray paint or the ability to climb a tree. Install radio and battery inside of big tool box, wire flasher...

I need specs and a scematic if possable. I purchased this amp about 16 years ago and have just gotten around to it's restoration. Does anyone know if this amp will clean up on rf splatter?

Mocat 40 needs stock mike replaced after 22 faithful years of service. I'm thinking D104 Hand held. Ever been done before? diagram of mocat mic pinout on radio available?

Does anyone have a schematic to build one?

O.K. I finaly found a 16 foot section of the aluminum rod at a industrial metal supply for $10.99! A few guys in the area have been following my rebuild with great interest, so a few gamma and betas will be fabbed up. A total of three antennas will com back from the grave. Thanks for the info!

Where did you find the aluminum rod stock? I've looked at all the big box hardware stores and can't seem to find it.