Search results

Just got a few contact/audio reports on both VHF and UHF with the Anytone 5888UV. Folks say the audio quality is VERY good, full sounding and no additional noises even at full power. So that's a good thing. I put it on a meter and the advertised power levels are spot on with actual output...

After speaking with Ed at Import Communication (wouxun.us) this morning, he emailed me a zip file that enabled the US Ham freq range. I think I got a unit that slipped thorough the cracks i.e. it wasn't even set up for any bands. I'm short on time today so I only enter a couple of repeaters...

I didn't reach out to seller. Yes- Performed hard resets on several occasions. If you mean "settings" being the tabs of left side of the page Limit CH.Edit and Normal CH.Edit and the other tabs then the answer is yes, if there is another page in the software that I'm not accessing please...

Ahhh. Software. When I first tried to program the Anytone, my USB driver would only work with the CHIRP software, the Wouxun/Anytone program wouldn't recognize the radio or USB cable due to the driver being too new. So I reverted to an older USB driver and now the Wouxun/Anytone program...

In my country, the 2M band is 144 to 148Mhz. As you see in my post the radio only allows me to use 144 to 146Mhz. I have always unlocked my radios just in case the world ends or Obama or DiFi imposes Sharia Law on Amateur radio licensees. So far I haven't had to go out of band. Time will...

I recently purchased the Anytone 5888 and am using the Wouxun/Anytone ver1.0 software for programming (for prior to 8-1-13 production unit). The USB Driver and read/write communication works fine in both directions. Issue: I can't get the radio to TX outside of the 144Mhz to 146Mhz range on...