Search results

Thank You for helping me. I will try to replace those parts. And see what happens. Thank you again. Question, would you know where I could purchase those parts. Thanks

I do appreciate your help. Thank you. To your question? Yes, ok when I transmit I same channel like ch6 and I put my spare receiver on same ch6 I have no problem. Then when I change channel on the spare radio to ch 7 I do not receive signal the only thing I hear is a low crackling audio.

Yes but in East NC most of the time it been very quiet. I do have another system set up so I can listen to compare the receiver AM band it is working good I just have channels problem but I did Eject RF signal into the hole AM band has issue all of the channels it look like are doing the same...

I do appreciate to answer my question I do Thank you. But is correct Ch 7 is not same as Ch 9. but I do not know if the hole AM band is doing same thing the AM band has been very quiet so only Channels I could hear. Is there anything I could do check maybe voltage or parts. Thank You

Yes I do have a frequency counter I ck on channel 6 Tx and it is on money. could you tell me which adjustment they should not touched i will ck to see if there is any damage. Thank You

To my knowledge this receiver does not have a 10KHz switch on the front panel.

I purchased this unit from Ebay. The seller said that this receiver is working fine but it does have a bad amp. When I received the unit? I check it out Amp it was not working. But the problem is on the AM band with the receiver same channels I could hear same if I went channel up or down more...

rci 2995dx cf 2 channel or same channel help If I'm listening to channel 6 then I go to channel 7 It is same channel than 6 same as ch9 it same ch10 and ch28 same as ch 29 I need help