Toggle sidebar Toggle sidebar
  • You can now help support WorldwideDX when you shop on Amazon at no additional cost to you! Simply follow this Shop on Amazon link first and a portion of any purchase is sent to WorldwideDX to help with site costs.

572B input impedance?

FL2100B Linear Amp was found to have a high input VSWR between 2-3:1 on 20, 15 & 10M bands.
With RF drive straight thru via Bird Thruline to 50 ohm dummy load I found VSWR was excellent at 1:1.
On inspecting the RF path taken (with key down with 800vac disconnected) via band switch and AMP tuning Pi network it was found to have a high VSWR on 14, 21 & 28MHz bands. Tuning those bands on input to Amp did little to achieve a low VSWR !!
Any suggestions would be appreciated to achieve a lower VSWR.
73s
 
Check bandswitch. Amazing how those cook when driven with a trashy radio. Could be bad cap, but with all of them reading high. I’m betting on harmonics arced bandswitch. Seen it many times
 
  • Like
Reactions: Tokin

dxChat
Help Users
  • No one is chatting at the moment.
  • @ BJ radionut:
  • @ COWBOYS:
    Denton GL 1000 ham amp comes on, but will not key up
  • @ COWBOYS:
    What can I do to make my Denton GLS 1000 amp to load ?
  • @ AudioShockwav:
    Try starting a new thread in the Amplifier section and asking the question, more people will see it to respond.
  • @ iw7ed:
    hello


      Top Bottom