I see some guys put their diodes, resistors and such directly on top of the caps. Some people build it in the form of a board with traces going from the common diode and common resistor banks over to the caps which are also grouped together.
SO is their a best practice or does it not matter at all? I am just wondering which way if more durable. I was thinking that if built on top ofthe caps air can flow totally around the parts. If I build it on a board then the heat is concentrated and air flow is not as good.
I guessing I am over thinking it but it does hurt to ask?!?!
SO is their a best practice or does it not matter at all? I am just wondering which way if more durable. I was thinking that if built on top ofthe caps air can flow totally around the parts. If I build it on a board then the heat is concentrated and air flow is not as good.
I guessing I am over thinking it but it does hurt to ask?!?!