anytone5555 v6

[jonnyshoot]

Hi im new to all this?
So i started with a AnyTone5555 v6 works well BUT when i put a small amp on to it, it reads in the display 5 HI with a hi pitch noise
Any one know how to fix the problem with out getting rid of the rigop:

Thanks
JDop:

 

[magnuman]

Use the software and turn off the hi SWR alarm.
At the same time, turn the warning to the maximum amount possible (as well as dissabling the hi swr alert) The noise should stop and radio will keep transmitting but you may still see the warning flash on the screen but it will not affect the transmission

 

[Robb]

If it is reading a SWR of 5; then perhaps you might want to heed that as a WARNING?
Might be wise to inspect your coax jumper or run it w/o the amp until you find the problem?

 

[hotrod]

Use the software and turn off the hi SWR alarm.
At the same time, turn the warning to the maximum amount possible (as well as dissabling the hi swr alert) The noise should stop and radio will keep transmitting but you may still see the warning flash on the screen but it will not affect the transmission

do all that ,then check swr with external meter or antenna anylizer

 

[AudioShockwav]

This is an issue with these radios, It seems to be a common problem.


73
Jeff

 

[jonnyshoot]

Thanks
Will check out allop:

JD