Buddy Hex. mounting??

[Old Barney]

I had a home built Hex beam for a couple years. I like the Hex beam configuration. worked fine for awhile then the Floriduh sun killed the fiberglass spreaders. I have new spreaders for my home built but the center support is now degraded also.
So I bought the buddy hex. I wish I could fasten it to my existing rotor at 30 feet. BUT the mounting is some off size and shape not standard to any mount I have seen.
I guess I may try some hose clamps to clamp the odd shape and size to the mast I have on the out side??
Any one have a suggestion for mounting this odd shape and size stick supplied. I (if richer) I could buy their tripod mount. and still not be able to mount on my standard rotor on my existing tower.
I just had a quad bypass and still recuperating so no hurry yet to tilt over my tower and fasten the strange mount ALONE!
Just getting suggestions and a solid way to fasten this thing safely. The rotor is a tail twister that is mounted to the tower top that works very well. I don,t and could not afford some other rotor now after hospital bills.
Any suggestions are welcome
Old Barney KD4IPN

 

[Crawdad]

Photos please.........

 

[unit_399]

YES. . . Photos.

 

[Old Barney]

This is the photos of the Mount Buddy pole sent for mounting. I'm not sure how to fasten it to a standard mount. I call a standard mount I have that is 1 1/2 inch pipe.

This is the piece I was sent to mount the Buddy Hex Yes it is hollow and not perfect round

 

[Old Barney]

The mount is made of some composite stuff I guess its strong?? I did not bend this out of round it slides in to the bottom of the hex antenna mount and has a clamp to fasten this into the bottom. I guess I can fasten it to the outside of standard mast size with worm gear clamps. Like hose clamps??

 

[Crawdad]

If it was me, I'd find a different, more rigid way. If I mounted my Hex on that the first good gust of wind would have it on the ground. But that's me.