Hello,
I want to rebuild/convert a D&A MDX200/Mavrick. I plan on removing the 4 final 6lq6's tubes and replace them with
31lq6 tubes and wire the heaters in series. I Know it can and has been done in the past using 4x31 volt tubes. But i am not
smart enough to know what else i need to do in support of this? I did post this elsewhere on the internet and it almost started
a war between a bunch of guys so i just said thank you and ended it. The tubes i am using are indirect heaters that did come up
and that makes a good start or so i was told. From what i understand i just have to pull from the 120 volt going into the Amp and
just run the 4 heaters in series? I do plan on running the power thru a power switch so the power does not run 24x7 but what else do
i need to do to 1. make it safe. 2 to do it right! I have read about it being done many times infact i even read about it in a bearcat? amp
on this forum. Please help me do it right and not burn down my house. Thank you all.
I want to rebuild/convert a D&A MDX200/Mavrick. I plan on removing the 4 final 6lq6's tubes and replace them with
31lq6 tubes and wire the heaters in series. I Know it can and has been done in the past using 4x31 volt tubes. But i am not
smart enough to know what else i need to do in support of this? I did post this elsewhere on the internet and it almost started
a war between a bunch of guys so i just said thank you and ended it. The tubes i am using are indirect heaters that did come up
and that makes a good start or so i was told. From what i understand i just have to pull from the 120 volt going into the Amp and
just run the 4 heaters in series? I do plan on running the power thru a power switch so the power does not run 24x7 but what else do
i need to do to 1. make it safe. 2 to do it right! I have read about it being done many times infact i even read about it in a bearcat? amp
on this forum. Please help me do it right and not burn down my house. Thank you all.