Toggle sidebar Toggle sidebar
  • You can now help support WorldwideDX when you shop on Amazon at no additional cost to you! Simply follow this Shop on Amazon link first and a portion of any purchase is sent to WorldwideDX to help with site costs.

D104/TUG8 wiring for Kenwood TS-120S?

K

KC8MWG

New Member
Oct 18, 2023
4
2
3
55
I have a D-104 mic on a T-UG8 amplified base that I want to use with my Kenwood TS-120S transceiver. How do I need to wire the plug so that it will work correctly with my radio?
 

KC8MWG said:
I have a D-104 mic on a T-UG8 amplified base that I want to use with my Kenwood TS-120S transceiver. How do I need to wire the plug so that it will work correctly with my radio?
Click to expand...
Not sure about the wiring but if the 120S is anything like my 140S you will probably need to put an attenuating resistor in the mics audio output line. I use a Turner CS-1 on my Kenwood TS-140S and without the resistor the output from the mic was too much for the radio even with the mic gains barely cracked open.
 
  • Like
Reactions: midnight special

dxChat
Help Users
  • No one is chatting at the moment.
  • @ BJ radionut:
    +1
  • @ heartbreaker3473:
    Hello gentlemen and Ladies. I have the dreaded RCI-2990 receive issue where my radio gets distorted when people get close to my location. I found the C90 Capacitor, but I can not for the life of me find the C89 capacitor. Can or does anyone have a picture of the exact location of C89 ? Thank you in advance, Wes
  • @ AudioShockwav:
    Wes, it's better if you start a thread on the main forum, more people are going to see your question.
  • @ heartbreaker3473:
    Okay, sorry, will put in a forum
  • @ heartbreaker3473:
    I put it in the general disscution help area and started a new thread. Thank you for letting me know.


      Top Bottom