I pulled this kit out of a non working radio today. No luck on identifying what kind of kit it is or the hookup procedure to see if it still works. Here are a couple pics showing all distinguishing marks:
Top side of the two pieces. Smaller one gets soldered directly into the spot where the ribbon cable from normal channel selector would go. 3 wire connector connects it to the bigger board which had a red and black wire heading to the board...im assuming power and ground...and then two wires heading to the clarifier.
http://prntscr.com/4lo8rc
http://prntscr.com/4loa5w
Any help identifying these would be greatly appreciated
Top side of the two pieces. Smaller one gets soldered directly into the spot where the ribbon cable from normal channel selector would go. 3 wire connector connects it to the bigger board which had a red and black wire heading to the board...im assuming power and ground...and then two wires heading to the clarifier.
http://prntscr.com/4lo8rc
http://prntscr.com/4loa5w
Any help identifying these would be greatly appreciated