• You can now help support WorldwideDX when you shop on Amazon at no additional cost to you! Simply follow this Shop on Amazon link first and a portion of any purchase is sent to WorldwideDX to help with site costs.

HR-2510 driver current problem

codecxbox

Active Member
Jul 28, 2021
89
46
28
Hi..
I installed only the driver 2166 which is new, and tested current on the test points..it goes from 0.30 to 1.3 and I stopped there, was getting to hot...all trimpots are adjusted accordingly by the service manual..any suggestions?
 

could be..although it was bought from a shop, not online..
In case I get a genuine, and it happens again, what should be checked? there was a bit burned 100 ohm bias resistor, and I replaced it for a new one
 
I have a TRC 449 that has the same test points bridge..thinking about comparing current idle and activity at the test points, to see if both act similar
 

dxChat
Help Users
  • No one is chatting at the moment.
  • dxBot:
    Tucker442 has left the room.
  • @ BJ radionut:
    LIVE 10:00 AM EST :cool:
  • @ Charles Edwards:
    I'm looking for factory settings 1 through 59 for a AT 5555 n2 or AT500 M2 I only wrote down half the values feel like a idiot I need help will be appreciated