• You can now help support WorldwideDX when you shop on Amazon at no additional cost to you! Simply follow this Shop on Amazon link first and a portion of any purchase is sent to WorldwideDX to help with site costs.

HR2600

Cabover Bob

Sr. Member
Nov 17, 2020
416
664
103
I have a nice condition Uniden HR2600 that I'm considering selling. It has a very small crack in the faceplate between two keypad openings. It is still boxed up from being in the hands of Roger Bird, I can get pics later today if there is any interest. I do not have a mic wired up for this rig yet, but I do have a couple at Superior CB for various repairs, one will be getting channel buttons. I will include it, the original bracket and a new power cord.

From RB :
Todd,

The radio is finished.
The receive came up +14 bars ! and I have aligned the tx and RX and set center slot on the RIT..
Adjusted the BIAS, and set the TX too 40 - 45w SSB and 15w AM dead key.
I ahve turned up the audio, and installed an external speaker jack.
I replaced the Cpu capacitor and removed the all the bad glue.

the work is as follows:
Chipswitch and socket $90
installation $40
External speaker $25
-------------------------------------
= $155
shipping and insurance $20
----------------------------------------- Total: $175 :end

I have around $275 invested, and I realize that I may not recover fully, so I am open to reasonable offers.

Todd
 
Last edited:

Here's a few pics.

Todd
 

Attachments

  • 20220411_083437.jpg
    20220411_083437.jpg
    2.9 MB · Views: 39
  • 20220411_083357.jpg
    20220411_083357.jpg
    1 MB · Views: 38
  • 20220411_083443.jpg
    20220411_083443.jpg
    7 MB · Views: 32
  • 20220411_083449.jpg
    20220411_083449.jpg
    5.7 MB · Views: 32
  • 20220411_083508.jpg
    20220411_083508.jpg
    976.8 KB · Views: 37
  • Like
Reactions: Shadetree Mechanic
This rig is boxed up and ready to be shipped to your van down by the river, who wants to make a deal ?
 

dxChat
Help Users
  • No one is chatting at the moment.
  • dxBot:
    Tucker442 has left the room.
  • @ BJ radionut:
    LIVE 10:00 AM EST :cool:
  • @ Charles Edwards:
    I'm looking for factory settings 1 through 59 for a AT 5555 n2 or AT500 M2 I only wrote down half the values feel like a idiot I need help will be appreciated