I have a nice condition Uniden HR2600 that I'm considering selling. It has a very small crack in the faceplate between two keypad openings. It is still boxed up from being in the hands of Roger Bird, I can get pics later today if there is any interest. I do not have a mic wired up for this rig yet, but I do have a couple at Superior CB for various repairs, one will be getting channel buttons. I will include it, the original bracket and a new power cord.
From RB :
Todd,
The radio is finished.
The receive came up +14 bars ! and I have aligned the tx and RX and set center slot on the RIT..
Adjusted the BIAS, and set the TX too 40 - 45w SSB and 15w AM dead key.
I ahve turned up the audio, and installed an external speaker jack.
I replaced the Cpu capacitor and removed the all the bad glue.
the work is as follows:
Chipswitch and socket $90
installation $40
External speaker $25
-------------------------------------
= $155
shipping and insurance $20
----------------------------------------- Total: $175 :end
I have around $275 invested, and I realize that I may not recover fully, so I am open to reasonable offers.
Todd
From RB :
Todd,
The radio is finished.
The receive came up +14 bars ! and I have aligned the tx and RX and set center slot on the RIT..
Adjusted the BIAS, and set the TX too 40 - 45w SSB and 15w AM dead key.
I ahve turned up the audio, and installed an external speaker jack.
I replaced the Cpu capacitor and removed the all the bad glue.
the work is as follows:
Chipswitch and socket $90
installation $40
External speaker $25
-------------------------------------
= $155
shipping and insurance $20
----------------------------------------- Total: $175 :end
I have around $275 invested, and I realize that I may not recover fully, so I am open to reasonable offers.
Todd
Last edited:
