You can now help support WorldwideDX when you shop on Amazon at no additional cost to you! Simply follow this Shop on Amazon link first and a portion of any purchase is sent to WorldwideDX to help with site costs.
I think that is the coil that balances power output between ch 1 and ch 40. It should be adjusted AFTER L18 & L17. If you have looked at the alignment procedure, it should be explained. It is adjusted after the RF output coils have been peaked. I'll look at the tune-up procedure and check it again.
L10 is used to set the dead key watts @ 4 on ch 19.
There is another coil that looks like that one just to the right and to the back. I think it is L20. DON'T adjust that one for ANY reason. That one adjusts the harmonics and keeps them out of the radio's output. It takes a special piece of VERY expensive equipment to do that adjustment ( a 'spectrum analyzer' - about $4k!). That is one point for any radio that I will not adjust for that reason. Solid advice: leave that one alone.
Robb,
You are correct L18, L17, then L14.
Some instruct to:
1) Pry off wax to adjust L14
2) Heat wax to adjust L14
How would you handle the wax when making an adjustment(s) to L 14?
Robb,
You are correct L18, L17, then L14.
Some instruct to:
1) Pry off wax to adjust L14
2) Heat wax to adjust L14
How would you handle the wax when making an adjustment(s) to L 14?
This forum does not allow a single user to have more than one username. If anyone wants to change their username contact an admin and it will be done. Multiple accounts belonging to the same member will be deleted without warning.