Toggle sidebar Toggle sidebar
  • You can now help support WorldwideDX when you shop on Amazon at no additional cost to you! Simply follow this Shop on Amazon link first and a portion of any purchase is sent to WorldwideDX to help with site costs.

Monitor Your Ham Radio With An Oscilloscope (VIDEO)


Very cool. I run a Yaesu FT-101ZD in the shack with a YO-901 Scope attached. I have it setup to monitor my output and I can also use it as a band scope to find signals.
 
I have channel 1 monitoring my tx signal and channel 2 monitors my receiver IF so I can look at the signal of whom I am talking too. My Kenwood TS-820S has the rx IF OUT port.
 
Captain Kilowatt said:
I have channel 1 monitoring my tx signal and channel 2 monitors my receiver IF so I can look at the signal of whom I am talking too. My Kenwood TS-820S has the rx IF OUT port.
Click to expand...
If I would hook it up to the FT-901dm I am repairing then I could monitor incoming sigs as well but the 101zd wont work that way with the YO-901.
 

dxChat
Help Users
  • No one is chatting at the moment.
  • @ BJ radionut:
    +1
  • @ heartbreaker3473:
    Hello gentlemen and Ladies. I have the dreaded RCI-2990 receive issue where my radio gets distorted when people get close to my location. I found the C90 Capacitor, but I can not for the life of me find the C89 capacitor. Can or does anyone have a picture of the exact location of C89 ? Thank you in advance, Wes
  • @ AudioShockwav:
    Wes, it's better if you start a thread on the main forum, more people are going to see your question.
  • @ heartbreaker3473:
    Okay, sorry, will put in a forum
  • @ heartbreaker3473:
    I put it in the general disscution help area and started a new thread. Thank you for letting me know.


      Top Bottom