Im helping a friend of mine set up dual antennas but one will be a dummy antenna. but anyway the mounts are in a aluminum toolbox with rubber between the bed rails and tool box. so im pretty sure its not grounded good.so i ran a ground wire from the mount to the frame. The SWR when you key the mike it pegs the guage. The radio is a Cobra 29 NW. Its not the radio we hooked my Wilson 1000 mag mount and the SWR was about 1.4 and it worked fine. Anybody got any ideas what could be the problem?
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an alternative browser.
You should upgrade or use an alternative browser.
-
You can now help support WorldwideDX when you shop on Amazon at no additional cost to you! Simply follow this Shop on Amazon link first and a portion of any purchase is sent to WorldwideDX to help with site costs.
Need some help with set up
- Thread starter frogmanS-6
- Start date
9
995
Guest
i ran a ground wire from the mount to the frame
What part of the mount? Sounds like you have it connected directly to the hot. It should be from one of the mounting bolts.
true, sounds like a direct short. maybe his coax seeing you tested the wilson and that used your coax attached to the antenna.
i ran it off one of the mounting bolts but im and wondering if that chrome plating on the mount is causing the problem
9
995
Guest
1. What does it do without the ground wire?
2. Can you try a different section of coax?
3. Can you post a pic of the mount?
2. Can you try a different section of coax?
3. Can you post a pic of the mount?
dxChat
- No one is chatting at the moment.
-
-
-
-
@ AudioShockwav:Try starting a new thread in the Amplifier section and asking the question, more people will see it to respond.
-