• You can now help support WorldwideDX when you shop on Amazon at no additional cost to you! Simply follow this Shop on Amazon link first and a portion of any purchase is sent to WorldwideDX to help with site costs.

Networking Six 5V 70A Supplies

DTB Radio said:
Pulled a bit over 140 amps from it today. I had someone watch the current meter while I keyed at progressively higher drive levels for about 2 seconds each, with a short break in between. Never dropped below 15 volts. I don't think the smoke and mirrors post is in the foreseeable future!

You won't smoke it like that... If that's the level your going to run it at, your "duty cycle" is so low you would never work them...

Think about it, 2 second key ups with 10 seconds off they key... That's 15 - 20 percent?


You should be able to run a sweet sixteen and driver with that setup. Congrats. I wouldn't go much larger than that, though. Each 2879 = 20 amps :)

==Toll_Free
 
yes, we talked about just using the [small] resistance in the wire, coiled up, might have worked.
 
Got some pictures up finally. Here you go:

supply1.jpg

supply2.jpg

supply3.jpg

supply4.jpg

supply5.jpg

supply6.jpg
 

dxChat
Help Users
  • No one is chatting at the moment.
  • @ heartbreaker3473:
    Hello gentlemen and Ladies. I have the dreaded RCI-2990 receive issue where my radio gets distorted when people get close to my location. I found the C90 Capacitor, but I can not for the life of me find the C89 capacitor. Can or does anyone have a picture of the exact location of C89 ? Thank you in advance, Wes
  • @ AudioShockwav:
    Wes, it's better if you start a thread on the main forum, more people are going to see your question.
  • @ heartbreaker3473:
    Okay, sorry, will put in a forum
  • @ heartbreaker3473:
    I put it in the general disscution help area and started a new thread. Thank you for letting me know.